For my resin printer setup I bought a mylar-covered grow tent from Vivosun which has all the hookups necessary for an inline fan & carbon filter. I zip it up 95% of the way so it's negative pressure and pulling the fumes through the filter.
I can't smell anything after the filter—not even the 99% pure IPA which smells much worse than Siraya Tech Fast resin—so I don't bother venting outside when it's cold out; it vents into the unfinished basement side room.
I wear a respirator, thick rubber gloves, treat every surface as "hot," and UV cure all my paper towels and anything that resin touched.
My Ultimaker sits on the desk in my office and I mostly print on it at night. It doesn't get much use.
I can't smell anything after the filter—not even the 99% pure IPA which smells much worse than Siraya Tech Fast resin—so I don't bother venting outside when it's cold out; it vents into the unfinished basement side room.
I wear a respirator, thick rubber gloves, treat every surface as "hot," and UV cure all my paper towels and anything that resin touched.
My Ultimaker sits on the desk in my office and I mostly print on it at night. It doesn't get much use.