I'd love to see a youtube video of your cleaning methodology.
Most of the videos from HVAC people are... sketchy to the say the least.
I've seen videos where they dismantle the whole indoor unit and leave the coil just hanging from the line set or zip tied to the backplate while they take the fan and drain pan outside to clean.
One easy thing we've found that helps with drain clogs is to use a shop vacuum from outside to suck it out (using a towel/rag to get a good pressure seal). Takes around 5 minutes per drain per cooling season.
I'll try recording something next time I clean one of the units (one needs a deep clean this spring); no promises though. In the meantime, here are some quick notes/resources.
- I cover the electronics in a garage bag held with tape. No need to unscrew the black cover over the power wires to disassemble (I unnecessarily removed this a few times heh).
- I ended up really liking this cleaning shrowd after trying a few; the hard pieces on the sides are key for making it easy to secure nicely, which many others lack: https://www.amazon.com/gp/aw/d/B083S85X97
- I spend more time (like 30min+) spraying the blower wheel so it spins. I alternate spraying with fresh water with spraying diluted "Lemocide" (@10% dilution) from a spray bottle a bunch of times depending how dirty it is. I use this <https://snowjoe.com/products/sun-joe-wa24c-lte-24v-150-psi-m...> which at 100 PSI is 10x stronger than a hand pump sprayer, but 10x weaker than a real pressure washer. I.e. the sweet spot IMO.
- I use foaming coil clean from a can to clean the fins if they're particularly dirty. (WARNING: I have not used in the same cleaning as the Lemocide since I haven't confirmed if they're compatible, so be careful of any reactions if you use both in the same cleaning.)
- I take the outer casings outside for a quick rinse with the hose and dish soap if they're really dusty.
- I tape cheap plastic mirrors at 45 degree angle above the unit so I can see it from above and carefully vacuum the back coil (there are 3 folded over in a U, and you can only see 2 from the front). Otherwise this just accumulates junk and is hard to see. This also really helps with finding the 3x clips at the top of the case that secure it to the back housing.
I may have a few more notes worth sharing at some point; feel free to ping me if you have any specific questions.
Edit: See also this quick video on unclogging the drain line on a Daikin (though I used the sprayer against the tube instead of my mouth...): https://m.youtube.com/watch?v=GDrHe-rli98
Most of the videos from HVAC people are... sketchy to the say the least.
I've seen videos where they dismantle the whole indoor unit and leave the coil just hanging from the line set or zip tied to the backplate while they take the fan and drain pan outside to clean.
One easy thing we've found that helps with drain clogs is to use a shop vacuum from outside to suck it out (using a towel/rag to get a good pressure seal). Takes around 5 minutes per drain per cooling season.