Yes you are right as far as LS engine builders there's loads. I could have ordered a crate engine from Texas Speed and been done with it. And yes for hours of my time spent vs hours of money saved I lost a ton of money. But all it takes is one very small mistake to make an engine short lived with these exacting tolerances. I'd rather blame myself than deal with someone kicking the blame back. It was also a personal satisfaction thing.
My wife's engine had an issue and it was the middle of winter so I said whatever let's just have a shop fix it. In the process they "flushed the transmission" and it failed 4 days after we got the car back. Of course they stonewalled us and I can't prove they broke it. So I ordered a late model wreck transmission and replaced it and 3 years later still running strong.
But I then decided that I would never be in that position again where someone could tell me it wasn't their problem and get me aggravated. With this engine I built it from raw parts. I had the block machined, and I had the tools to verify.
It was certainly not worth my time, but as you said I love working on cars too.
I have a buddy that is adamant about not flushing transmissions if you dont have a issue because he think its guaranteed to have an issue after, from his experience. lol
There is some truth to that, but not never. A flush will dislodge any metal shavings and crud from the moving parts. The filter should catch these, but the filters themselves can get clogged, and then bye-bye transmission.
Flushing can really be bad if you've never done a routine flush on a schedule. You don't want to go 150,000 miles before your first one. You would need a garage with a forced flush system to move it all out, and then probably flush again soon after to make sure all the gunk is out.
Transmission oil breaks down with heat and wear like any other, and will eventually contain sludge and dirt.
I'd concur with that. Note this was one of the notorious to fail JATCO nissan/mitsubishi transmissions. Blowing fluid through with pressure makes no sense. Sediment sitting in pans does not affect operation until it is agitated into suspension
The Nissan automatics and especially manuals(cd009) are fairly strong. It's their CVT that's the issues. I don't know why Nissan insist on using them with their V6's.
My wife's engine had an issue and it was the middle of winter so I said whatever let's just have a shop fix it. In the process they "flushed the transmission" and it failed 4 days after we got the car back. Of course they stonewalled us and I can't prove they broke it. So I ordered a late model wreck transmission and replaced it and 3 years later still running strong.
But I then decided that I would never be in that position again where someone could tell me it wasn't their problem and get me aggravated. With this engine I built it from raw parts. I had the block machined, and I had the tools to verify.
It was certainly not worth my time, but as you said I love working on cars too.